Filter
Top Products
2009 Portable Spa
LTR20091000, Rev. A
Operating Your Spa
www.calspas.com
18
Pump On/Off
This button allows the user to turn on and off the
ATS™ seat pump. Press this button once to turn the
pump on. Once on, the green LED light on the control
panel will illuminate, indicating that the system is
operational. To turn off the pump, press the “PUMP
ON/OFF” button a second time. Note: The pump
must be on prior to operating any other features of
this system.
Pulse Mode
This button allows the user to turn the ATS™ massage
control on and off. Press the pulse button once to
turn on the massage control. Once pressed, the
orange LED in position number 1will light, indicating
the number one pulse mode. Each press of either the
up or down button will move the orange LED up or
down to the next pulse mode.
Note: Allow one second between each button press.
Pressing the button quickly may cause improper
operation. To turn the pulse mode off and return to
normal pump operation, press the “PULSE MODE”
button a second time.
Up
This button allows the user to cycle up from one
through seven massage modes one at a time. Each
mode offers a different pulsating massage. Some
modes are faster than others, so just cycle through
them to nd the massage you like best.
Down
This button allows the user to cycle down through all
seven massage modes, one at a time.
Time Reset
Mode
Pulse mode will
normally run for
15 minutes then
automatically shut
off. For another
15-minute session,
press the “PUMP
ON/OFF” button
and the “PULSE
MODE” button. A green LED will blink and the pump
will run on high-speed mode as part of a 15-minute
cool down period. After that, the pump will stop
automatically and the green LED light on the panel
will continue to blink for one minute then shut off
automatically. After the second 15-minute session,
the system will run through a cool down cycle for up
to two hours. In this cool down mode, the user will
only be able to operate the pump (by again pressing
the “PUMP ON/OFF” button). However, the massage
mode will remain off until the cool down mode is
completed.
Pulse Mode System
Pulse mode system will shut off for two hours unless
reset by the following procedure. During this time the
pump will run at a maximum speed.
In the off position, press the “PULSE MODE” •
button once.
The green power light will ash to indicate •
reset.
Wireless Spa Monitor
The wireless spa monitor allows you to monitor and change your spa’s activity
from a distance. The table below describes each button’s function.
Light Operates spa light and LED mood lighting
Temp Display or adjust the set temperature control
Jet 1 Turn on or off jet 1
Mode Switch between Standard, Economy, and Sleep Modes
Adjustable Therapy System™