Filter
Top Products
2009 Portable Spa
LTR20091000, Rev. A
Operating Your Spa
www.calspas.com
10
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The 6200 and 6300 electronic control
panels display the actual water temperature
in degrees Fahrenheit. The displayed
temperature will only be current after the
pump has been running for at least two
minutes.
To display the temperature that the spa
is set to:
Press the • Temp button. The
temperature setting will ash.
While the display is ashing, each •
time you press Temp button, the
set temperature will change up or
down one degree.
If the desired temperature is •
opposite of the direction each press
of the button is making, release
button, allow display to stop ashing and then
press Temp button to change temperature the
other direction.
Standard, Economy and Sleep Heating
Modes
Your new spa is equipped with a heating feature that
gives you complete control of the heating system.
When the spa is powered up, it will automatically start
in standard heating mode.
St• will light briey on the main display. In this
mode, the heating system will automatically
maintain the set spa temperature. In the economy-
heating mode, the heating system will only activate
during ltration times.
Ec• will display solid if temperature is not current
and will alternate with spa temperature if measured
temperature is current.
Economy mode will heat the water to the set •
temperature while Sleep mode, indicated by a
SL on the main display, will also only activate
the heater during the ltering cycles but will
only heat the water to within 20°F (10°C) of the
set temperature. Like Economy mode, SL will
display solid when temperature is not current and
will alternate with actual temperature when it is
current.
NOTE: Displayed temperature will only be current after
the pump has been running for at least two minutes.
Switching Modes
Press • Temp button followed by the Light
button.
Press the same sequence to switch to the next •
mode.
Operating Your Spa
5100, 6200 and 6300 Electronic Control Operation
Initial Start up
When rst powered up, your spa will perform a self-diagnostic check and to into priming mode. The topside will
display PR to indicate this. Priming mode will be active for less than ve minutes. When the spa has nished
priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa
will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.
These instructions will describe features and options that your particular spa may not be equipped with.