Filter
Top Products
40
41
Quick Setup Instructions - Series 16C Temperature Controller
Experienced users, already familiar with the Series 16C, and using the
controller with PID outputs, may follow these condensed instructions to
autotune the controller and get started quickly once the instrument is prop-
erly mounted and wired, and the Security Level is set to . Once setup
is complete, we recommend changing the Security Level back to the most
restrictive level suitable for your application.
These quick setup instructions are not meant as a substitute for reading the
full instruction manual supplied with the controller. Please be sure to read
through the manual for specific details of operation and, most importantly, for safety precautions.
If you have any questions, or experience problems with setting up your controller, consult the full
instruction manual first and, if you still need assistance, contact your Athena representative or call
1-800-782-6776.
Menu Access Raise Lower Mode/Enter
1. Apply power. After self-check display stops, place controller in Standby mode by pressing and holding the
Mode/Enter key for 3 seconds, the
or key until appears, and then the key again.
will flash, alternating with the Process Value.
2. Press and hold the Menu Access
key for 3 seconds until is displayed. Press key once until
appears, then use
or keys to select sensor input type.
3. Press
to display
. Then press once to display . Use
or to select .
4. Press the key until Output 1 Action
is displayed. Select the desired output action using the
or keys. (Reverse = Heating)