Filter
Top Products
25
24
NOTE: The following seven parameters are only available when
multi-step ramp is selected.
Display Parameter Selection
Recycle Number 0-99,
(Recipe Executions)
Power Fail Resume Off
On
Ramp Times 1-8 0-9999 mins.
Ramp Events 1-8 Alarm 1 On
Alarm 1 Off
Alarm 2 On
Alarm 2 Off
Disabled
Soak Levels 1-8 Display Units, FS
Soak Times 1-8 0-9999 mins.
Soak Events 1-8 Alarm 1 On
Alarm 1 Off
Alarm 2 On
Alarm 2 Off
Disabled
Recipe (Ramp/
Soak) Menu
For Ramp Events and
Soak Events to be
employed, Alarm 1 or
Alarm 2 must be set for
event usage in the
Alarm Menu.
Supervisor Menu
Display Parameter Selection
Output 1 0 to 100%
Failsafe State of output
Output 2 0 to 100%
Failsafe State of output
Loop Break Time Off, 4-9600 sec
Highest Reading n/a
Lowest Reading n/a
Load Default
Parameters
Choosing “Yes” to Load Default Parameters resets all menu
parameters to factory settings.
The Failsafe State is
only enforced when
a problem is detected
with the process
input. It is not reli-
ably enforceable in
instances of internal
circuitry failure such as
EEPROM problems.
Output % High Limits
are ignored when the
unit enters a Failsafe
State.