Filter
Top Products
8
Security Levels
The security level feature allows you to limit access to the
menus, setpoint, and operating mode selection according to
the needs of your application. The security levels provided
are Key Lockout, Setpoint, Setpoint plus Mode, User,
Configuration, and Factory. To view or change security
level from the Process Variable display, press and hold the
Menu Access key for approximately 10 seconds.
(Ignore the menu label that will appear in the upper display
after approximately three seconds.) The controller will display
(Access Level) and the current security level label,
e.g., . Use the Raise
or Lower keys to index
through the security levels. Press the Mode/Enter key
once to select the new security level desired and return to the
Process Value display.
The controller’s initial
security level, set at the
factory, is Configuration
. When you have
completed configuring
the instrument, we
recommend the security
level be set to the most
restrictive level suitable
for your application.
Security Levels and Access Restrictions
Key Lockout Highest security level. No access to any
controller functions. To escape, follow
instructions above for changing security
levels.
Setpoint No access to menus. Only allows setpoint
value or output percentage (manual mode)
to be changed.
Setpoint
plus Mode No access to menus. Only allows setpoint
value, output percentage (manual mode),
or operating mode to be changed.
User All “Setpoint” level privileges as well as
access to Operating Mode, Autotune, and
Control menus.
Configuration All “User” level privileges as well as Input,
Output, Display, and Supervisor menus
Factory All “Configuration” level privileges as well
as access to Calibration menu.
NOTE: Removing this jumper on the microcontroller board disables
the keypad, thus preventing any operator access.
JMPØ3