Filter
Top Products
MAINTENANCE
1900 07/11 Maintenance Section 5-3
©2011 Alamo Group Inc.
MAINTENANCE
PARTS INFORMATION
LUBRICATION INFORMATION
General
Refer to the lubrication diagram and grease daily all the points shown.
1. Power take-off shaft - The PTO shaft should be regularly examined to ensure that it is in good condition
together with the guards. The universal joints should be greased very sparingly, i.e., one shot a week.
NOTE: Overgreasing a universal joint will blow out the cork or neoprene sealing rings that exclude the dirt from
the needle bearing inside.
2. The two halves of the plastic guard should be checked daily to ensure that they can spin freely on the
shaft. The nylon slip rings which support the guard on the drive shaft should be lightly greased at weekly
intervals.
3. The telescoping drive shaft should be similarly separated and grease applied to the internal shaft at
approximately 100 hour intervals.
4. Your Boom uses greased bushings that need lubrication, and with proper lubrication should last the
lifetime of the machine.
PARTS INFORMATION
Rhino mowers use balanced and matched system components for blade carriers, blades, cuttershafts, knives,
knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested to Rhino
specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The use of “will fit”
parts may reduce mower performance, void warranties, and present a safety hazard. Use genuine Rhino
mower parts for economy and safety.
(SPRM-1)
SEE YOUR RHINO DEALER