Filter
Top Products
Assembly 17
MAN0169 (Rev. 5/6/2005)
Figure 15. Caster Wheel Installed
Install Optional Skid Shoe Kit
(Rear Blade)
1. Remove plow bolts from each end of cutting edge.
2. Attach skid shoe bracket (1) to rear of moldboard
with plow bolt (2), washer (3), and hex nut (4)
supplied in kit.
3. Adjust skid shoe to desired height.
4. Repeat steps for opposite side of moldboard.
Figure 16. Skid Shoe Installation (Typical)
Figure 17. Skid Shoe Installed (Right Side)
Quick Hitch Bushing Kit (Optional)
Figure 18. Quick Hitch Bushing Kit
1. Place sleeve (1) over lower 3-point pin, secure with
klik pin (2). Repeat for opposite side.
2. Place sleeve (5) between A-frame plates. Secure
through upper hole with cap screw (6), lock washer
(4) and nut (3).
12
13
DP4
9
9. Tail wheel arm
12. 1/2 Flange lock nut
13. 1/2 NC x 1-3/4 Cap screw GR5
2
4
3
1
CD6157-1
1. Skid shoe bracket
2. 5/8 NC x 2 Plow bolt
3. 5/8 Hardened flat washer
4. 5/8 NC Hex nut
CD6221
1
2
3
4
5
6
1. .938 x 1.438 x 1.19 Sleeve
2. 7/16 x 11/32 Klik pin
3. 3/4 NC Hex nut
4. 3/4 Lock washer
5. .812 x 1.25 x 1.75 Sleeve
6. 3/4 NC x 3 Cap screw GR5