Filter
Top Products
14 Maintenance
MAN0169 (Rev. 5/6/2005)
TAIL WHEEL ADJUSTMENT LRC60
(OPTIONAL)
1. Raise rake until tail wheels clear the ground.
2. To raise tail wheels, remove klik pin (10) and
washer (17). Allow clevis and shaft (7) to slide
down in tail wheel arm (9). Do not remove shaft
completely from wheel arm.
3. Rotate height adjustment spacer(s) (8), align slot
with groove at bottom of shaft, and remove
spacer(s).
4. Slide clevis and shaft back into position; place
removed spacer(s) over top of shaft.
5. Install klik pin and washer.
6. To lower gauge wheels, reverse the procedure.
NOTE: Use a good multi-purpose to grease pivot
tube and caster wheel every 8 hours of operation.
Figure 11. Caster Wheel Adjustment
CLEANING
After Each Use
● Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Inspect machine and replace worn or damaged
parts.
● Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
● Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
● Remove the remainder using a low-pressure water
spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
● Inspect machine and replace worn or damaged
parts.
● Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
● Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
8
9
10
17
CD6157-3
7
7. Clevis
8. 1/2" Height adjustment spacer
9. Tail wheel arm
10. Klik pin, 1/4 x 1-3/4
17. Washer, 1-1/6 x 1-9/16 x 10 ga