Filter
Top Products
22 Assembly
32695 (Rev. 11/17/2006)
rear. Place clevis portion of bracket inward and install
chain idler in rear hole of bracket clevis.
Install brackets to tractor as shown in Figure 17. There
is a plate bolted over clutch housing. When installing
right bracket, remove two bottom bolts attaching this
plate to tractor. There is a bolt just above these bolts.
Remove it. Remove washer and reinstall bolt. Be sure
to use the 14 mm bolts provided in mower kit for
bracket installation. Place heavy duty lock washer over
each bolt.
Figure 17. Right Front Lift Bracket Installation
Figure 18. Left Front Lift Bracket Installation
ATTACHING MOWER TO TRACTOR
Position mower under tractor. It will be necessary to lift
front wheels off ground.
■ Use care when moving mower under tractor. Do
not get under tractor. Be sure lifting device is safe.
If a lifting device is not available, the mower frame is
strong enough to back the tractor over mower. Use
care to prevent damage to painted surface when using
this method.
Place a wooden block behind each rear tire to act as a
ramp. Do not spin tires against mower frame. Back on
then drive off.
1. Steering Gear Case*
2. 5/8 Heavy Lock Washer
3. 14 mm x 1.5P x 35 mm Bolt
4. Right Front Lift Bracket
5. 1/2 x 2 Clevis Pin
6. 3/16 x 1 Cotter Pin
7. Chain Idler
8. Oil Filter*
* Tractor Parts
1. Chain (to right front lift bracket)
2. Left Front Lift Bracket
3. Chain (to left front lift bracket)
4. 1/2 x 2 Clevis Pin
5. 3/16 x 1 Cotter Pin
6. 1/2 x 2 Clevis Pin
7. Chain Idler
8. 14 mm x 1.5P x 35 mm Bolt
9. 5/8 Heavy Lock Washer
10. Left Tractor Foot Rest*
* Tractor Part
A CAUTION