Filter
Top Products
20 Assembly
32695 (Rev. 11/17/2006)
TRACTOR PREPARATION
Remove lower 3-point lift arms, connecting links, draw-
bar and sway chains from tractor.
On tractors equipped with draft control, replace draft
control top link bracket with Kubota right and left top
link holders, part #99571-2214-0 and #99571-2215-0.
Rear Tractor Tire Adjustment
Adjust rear tires to provide spacing between tires as
given in chart.
Idler Bracket Installation
See Figure 13. Position idler bracket under tractor
housing and attach using bolt and lock washer
removed from tractor drawbar. Place a 5/8" flat washer
from mower parts package on each bolt. Insert bolt
through bracket and place a 5/8" flat washer on each
bolt. Use two bolts and lock washers removed from
tractor PTO shield and place a 1/2" flat washer over
each bolt. Use this hardware to secure rear of idler
bracket to tractor.
Insert carriage bolt (14) through right slot of idler
bracket as shown in Figure 13. Install a washer (10),
belt guide (13), two washers (10), pulley, lock washer
(11) and nut (12) on bolt.
Insert carriage bolt (14) through left slot of idler bracket
as shown in Figure 13. Install three washers (10), pul-
ley, lock washer (11) and nut (12).
Do not tighten nuts on idlers at this time.
Place right rear left angle (16) over square tube as
shown and clamp in place using clamp (7), bolts (9)
and nuts (2). Install left rear lift angle (3) in same man-
ner.
Install chain idler (8) in each lift angle with clevis pin (6)
and cotter pin (4).
Figure 13. Idler Bracket Installation
Rear Lift Installation
See Figure 14. Install lift lug (2) over rockshaft pin, slide
pipe sleeve over pin, and secure with Klik pin (3).
Repeat for opposite side.
1. Chain
2. 1/2 Lock Nut
3. Left rear Lift Angle
4. 3/16 x 1 Cotter Pin
5. 1/2 Standard Flat Washer
6. 1/2 x 2 Clevis Pin
7. Clamp Plate
8. Chain Idler
9. 1/2 x 3-3/4 Bolt
10. 5/8 Standard Flat Washer
11. 5/8 Heavy Lock Washer
12. 5/8 Lock Nut
13. V-Belt Guide
14. 5/8 x 2-1/4 Carriage Bolt
15. 12 mm x 1.25P x 26 mm Bolt*
16. Right Rear Lift Angle
17. 14 mm x 1.5P x 30 mm Bolt*
18. 14 mm Lock Washer*
19. 12 mm Lock Washer*
* Tractor Hardware