Filter
Top Products
Safety 7
FE-Series Mow”n Machine (12/23/2005)
Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
Do not drive or operate mower in tilt-up posi-
tion. Power unit stability is not adequate and result-
ing loads can damage or cause failure of tilt-up
mechanism.
Never leave a running machine unattended.
Moving steering levers rapidly from forward to
reverse or reverse to forward could cause loss of
control.
Do not operate power unit with attachment
removed. Attachment is required for power unit
stability.
Before dismounting power unit, follow these
steps: lower attachment to ground, shut off PTO,
set parking brake, shut off engine, position steer-
ing levers to neutral swing-out position, and
remove key.
This machine is not equipped for towing. Do not
tow any loads.
To avoid burns, DO NOT TOUCH the engine or
muffler immediately after operation.
MAINTENANCE
Before dismounting power unit, follow these
steps: lower attachment to ground, shut off PTO,
set parking brake, shut off engine, position steer-
ing levers to neutral swing-out position, and
remove key.
Before attempting to unplug vacuum hoses, dis-
engage PTO, stop power unit, and remove key.
Before performing any service or maintenance,
lower attachment to ground, turn off power unit
engine, remove key, and disconnect battery ground
cable (negative -).
Before working underneath, read manual
instructions, securely block up, and check stability.
Secure blocking prevents equipment from drop-
ping due to hydraulic leak down, hydraulic system
failure, or mechanical component failure.
Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
Do not work on mower in tilt-up position unless
deck is in a stable position.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate
Do not work on mower in tilt-up position unless
lock-up mechanism is in good condition. Replace if
damaged.
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Do not put Mow’n Machine into service unless
clutch is working properly. When the engine is at
full throttle, PTO-driven accessories must stop
within five seconds after the PTO switch is turned
to “OFF.” See your dealer for replacement
clutches.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Do not change engine governor settings or
overspeed engine.
Frequently check blades. They should be sharp,
free of nicks and cracks, and securely fastened.
Do not handle blades with bare hands. Careless
or improper handling may result in serious injury.
Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
Tighten all bolts, nuts, and screws to torque
chart specifications. Check that all cotter pins are
installed securely to ensure equipment is in a safe
condition before putting unit into service.
Use care to prevent battery acid from contacting
skin.
Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
(Safety Rules continued on next page)
(Rev. 8/22/2008)
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!