Filter
Top Products
28 Assembly
MAN0646 (Rev. 11/5/2007)
STRAIGHT LINE TRAVEL
1. Check tire pressure; tires must have equal air
pressure.
2. Check travel; drive forward with both steering
handles full forward at half throttle.
• If travel is not straight, adjust steering handle stop
bolt on opposite side of turn.
• If power unit turns to the left, raise steering stop
bolt on the right.
• If power unit turns to the right, raise steering stop
bolt on the left.
Figure 21. Left Side Steering Stop Bolts
INSTALL SINGLE TAILWHEEL (OPTIONAL)
1. Attach tailwheel spacer (22), and pivot mount
adapter (1) to rear of power unit frame using two
cap screws (21) and lock nuts (20).
2. Attach pivot housing (2) to pivot mount adapter and
power unit frame using four cap screws (18) and
lock washers (19).
3. Torque hardware to 35 lbs-ft.
NOTE: Rear tire pressure: 18 psi
Figure 22. Single Tailwheel Installation
DP4
1. Pivot mount adapter
2. Pivot housing
18. 3/8 NC x 4-1/2 HHCS GR5
19. 3/8 Lock washer
20. 3/8 Lock nut
21. 3/8 NC x 1-3/4 HHCS GR5
22. Tailwheel spacer
❖