Filter
Top Products
Operation 11
MAN0646 (7/6/2007)
OPERATION
The operator is responsible for the safe operation of
this Mow’n Machine. The operator must be properly
trained. Operators should be familiar with the power
unit, all attachments that will be used, and all safety
practices before starting operation. Read the safety
rules and safety decals on page 5 through page 10.
Operators must be instructed in and be capable
of the safe operation of the equipment, its attach-
ments, and all controls. Do not allow anyone to
operate this equipment without proper instructions.
Make sure attachment is properly secured,
adjusted, and in good operating condition.
Inspect and clear area of stones, branches, or
other hard objects that might be thrown, causing
injury or damage.
Do not operate power unit with attachment
removed. Attachment is required for power unit
stability.
Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
Handle fuel carefully; it is highly flammable.
Always use an approved container. Never remove
fuel cap or add fuel while engine is running. Allow
engine to cool before refueling. Wipe up all spilled
fuel before starting engine.
Keep bystanders away from equipment.
Do not operate or transport equipment while
under the influence of alcohol or drugs.
Keep hands, feet, hair, and clothing away from
equipment while engine is running. Stay clear of all
moving parts.
Never allow riders on power unit or attachment.
Never direct discharge toward people, animals,
or property.
Moving steering levers rapidly from forward to
reverse or reverse to forward could cause loss of
control.
Look down and to the rear and make sure area
is clear before operating in reverse.
Do not stop, start, or change directions sud-
denly on slopes.
Before dismounting power unit, follow these
steps: lower attachment to ground, shut off PTO,
set parking brake, shut off engine, position steer-
ing levers to neutral swing-out position, and
remove key.
Do not drive or operate mower in tilt-up posi-
tion. Power unit stability is not adequate and result-
ing loads can damage or cause failure of tilt-up
mechanism.
Do not operate PTO during transport.
Remove accumulated debris from this equip-
ment, power unit, and engine to avoid fire hazard.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Start engine from operator's seat after disen-
gaging power unit PTO and placing steering levers
in neutral.
Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
CAUTION