Filter
Top Products
Operation 15
MAN0646 (7/6/2007)
STOPPING ENGINE
1. Move throttle to 1/3 setting.
2. Allow engine to idle for several minutes.
3. Turn key to OFF position and remove.
Remove key and store in a secure location to
prevent unauthorized persons from operating
equipment.
Manual Fuel Shut-Off Valve
A manual fuel shut-off valve is located on top of the fuel
filter, on the right side of engine.
1. Place valve in the “ON” position before attempting
to start engine.
2. Place valve in the “OFF” position when changing or
cleaning the fuel filter.
Figure 3. Manual Shut-Off Valve
MOVING DISABLED POWER UNIT
Figure 4. Left Pump Dump Valve
Manually move a disabled power unit by following
these steps.
1. Locate dump valves on bottom of both hydraulic
pumps.
2. Turn hex head two full revolutions counter-clock
wise to open valve, using a 5/8" wrench or round
punch.
WEIGHT TRANSFER
When using weight transfer system, correct
counterweight must be used to maintain stability.
See counterweight chart in power unit manual or
contact dealer.
The weight transfer is designed to place an additional
load on the drive wheels, providing additional traction.
1. Attach mower to power unit and set to desired
cutting height.
2. Torque bolt on both sides to 35 lbs-in.
NOTE: Counterweight is needed to provide adequate
stability. Refer to the chart to determine your power
unit/mower combination, and the amount of counter-
weight required.
Counterweights are not required when power unit is
equipped with a grass catcher system.
Figure 5. Counterweight Requirement Chart
CAUTION
DP2
DUMP VALVE
Mower
FZ25D
With
ROPS
With
ROPS &
Sun
Shade
Grass
Catcher
52" Deck 0 lbs 50 lbs 100 lbs 0 lbs
61" Deck 0 lbs 50 lbs 100 lbs 0 lbs
72" Deck 50 lbs 100 lbs 150 lbs N/A
Snow Thrower 0 lbs 50 lbs 100 lbs N/A
Dozer Blade 0 lbs 50 lbs 100 lbs N/A
60" Sweeper 50 lbs 100 lbs 150 lbs N/A
(Rev. 8/22/2008)