Filter
Top Products
SECTION
2: EASY ASSEMBLY
To
assemble your snowthrower, you'll need:
1.
One quart of clean, high quality engine oil. (Refer
to "Specifications" on the inside back cover for
the recommended types and viscosities.)
2.
Two
7/16-inch wrenches:
3.
Two
'l2-inch wrenches (one of these should
be
an
open-end wrench):
4.
One 3/8-inch wrench.
5.
A small amount of multipurpose automotive
grease.
6.
One 5/16-inch wrench.*
7.
One automotive-type tire pressure gauge.
8.
One 9/16-inch wrench.*
9.
A clean funnel.
10.
A hammer and block of wood to tap the roll pin
into the plastic universal joint.
*You
can substitute adjustable wrench(es).
Before you
begin
assembly, read
this
Section
all
the
way
through
to
familiarize yourself
with
the
assembly steps. Then
gather
the
tools
you'll
need.
Compare the parts you received
in
the shipping
carton with the list below
to
make sure
you
received
everything. If
you
are missing any parts, please con-
tact your local servicing dealer or call the factory for
replacements.
Your
shipping carton should contain:
1.
The snowthrowerlenginelauger assembly.
2.
The handlebar assembly.
3.
The discharge chute assembly.
4.
The hardware package, which consists
of:
A. One roll pin.
B.
Two
#10-24 x
7/8
hex screws.
C.
Two
#10
flat washers.
D.
Two
#10-24 locknuts.
E.
Two
ignition
keys.
F.
One tie strap.
G.
Two
cable brackets.
H.
Six locknuts, 5/16-18.
I.
Two
spacers.
J.
Two
extra
5/16-18
shear bolts (for auger).
K.
Four
5/16-18
x
3/4
hex
flange screws.
7