Filter
Top Products
EASY
ASSEMBLY
)
B~
Figure
2-1
Step
1:
Attach
the
Handlebars.
1.
Remove the four loosely installed 5/16-18 x
7/8
flange screws from holes
A.
2. Place the lower ends of the handlebar assembly
on the outside of the upper rear corner of the
frame
as
shown
in
Figure
2-1
(Item
A).
Align the
two holes
in
the left side of the lower end of the
handlebars with the two holes
in
the left side of
the frame.
3.
Loosely install a 5/16-18 x
3/4
hex
flange screw
into each of these holes.
4.
Repeat the previous two steps for the right side of
the lower handlebars.
5.
Evenly tighten all four screws.
6.
Use the two 7/16-inch wrenches
to
check the four
handlebar control panel mounting screws (Figure
2-1,
Item
CC)
for tightness.
Step
2:
Connect
the
Ignition
Ground
Wires
1.
Run the black ignition ground wire down the left-
hand handlebar tube as shown
in
Figure
2-1
and
2-2 (Item
B).
2. Plug the connector
at
the lower end of the black
ignition ground wire into the terminal beneath the
Engine Control
Lever.
See Figure
2-1
(Item
B).
3.
Attach the black ground wire
to
the lower left handlebar
with the two tie straps. See
N
Figure
2-1
and 2-2 (Item
C).
Figure 2-2
8