Filter
Top Products
- 2 -
3) Remove the four B-4x5 screws from the side panel (L).
4) Open the top cover and remove the three P-4x8 screws that secure the side panel (L).
5) Lift the side panel (L) and put it aside.
6) Disconnect the fan motor harness from CN19 on the Main PC board, and then separate the side
panel (L).
7) Fix the cutter drive unit to the printer with the three SM-4x8 screws.
B-4x5 Screw
P-4x8 Screw
Top Cover
B-4x5 Screw
Side Panel (L)
SM-4x8 Screw
Cutter Drive Unit
Side Panel (L)
Fan Motor Harness
Fan Motor
CN19
Main PC Board
SM-4x8 Screw