Filter
Top Products
- 12 -
20) Fix the cutter drive unit to the printer with the three SM-4x8 screws.
21) Connect the 9-pin connector of the harness ass’y to CN7 and 2-pin connector to CN9 on the cutter
driver unit, respectively.
22) Fit the bush to the harness ass’y in the orientation as shown below.
23) Insert the harness ass’y into the hole in the main frame. Fit the bush into the hole.
SM-4x8 Screw
Cutter Drive Unit
CN7 (9 pins)
CN9 (2 pins)
Harness Ass’y
Bush
Harness Ass’y
Hole
Main Frame
Harness Ass’y
SM-4x8 Screw