Filter
Top Products
- 10 -
13) Raise the print head block until it stops.
14)
Remove the two SMW-4x8 screws that secure the strip sensors (TR) and (LED).
15)
Release the strip sensor (LED) harness from the cable clamp, and disconnect it from the shorter harness
of the strip sensor harness (TR).
Print Head Block
Stoppe
r
SMW-4x8B Screw
Strip Sensor (Tr)
SMW-4x8B Screw
Strip Sensor (LED)
Cable Clamp
Strip Sensor Harness
(for LED)
Shorter Harness of the Strip
Sensor Harness (for Tr)