Filter
Top Products
Reelmaster 2300–D/2600–D Hydraulic SystemPage 4 – 71
Rear Lift Cylinder
1. Hose connection
2. Hose connection
3. Hydraulic fitting
4. Hydraulic fitting
5. O–ring
6. Cap screw
7. Ram pivot pin
8. Pivot support
9. Lift pivot shaft
10. Lift cylinder
11. Cotter pin
12. Clevis pin
13. Lift arm
14. Flat washer
15. O–ring
Figure 63
8
7
6
3
2
5
4
15
5
15
10
1
9
12
14
13
11
ROD CLEVIS
14
Removal (Fig. 63)
1. Before removing any parts from the hydraulic man-
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
CAUTION
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
CAUTION
The rear lift cylinder is located near the
muffler exhaust pipe. To avoid possible
burns, allow the exhaust pipe to cool be-
fore working on the rear lift cylinder.
2. Label all connections for reassembly. Disconnect
hose connections (1 and 2) from hydraulic fittings (3 and
4). Allow hoses to drain into a suitable container.
Hydraulic
System