Filter
Top Products
Reelmaster 2300–D/2600–D Hydraulic SystemPage 4 – 69
1. retaining ring
2. O–ring
3. Head
4. Backup washer
5. O–ring
6. Shaft
7. O–ring
8. Piston
9. Uni–ring
10. Lock nut
11. Barrel
12. Dust seal
Figure 60
5
1
3
7
8
9
11
6
4
2
12
10
Disassembly (Fig. 60)
1. Remove oil from the cylinder into a drain pan by
slowly pumping the cylinder shaft (6). Plug both ports
and clean the outside of the lift cylinder.
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the pivot only. Do
not close vise enough to distort barrel (11).
2. Mount lift cylinder in a vise so that the shaft (6) end
tilts up slightly. Remove and discard dust seal (12).
3. Rotate head (3) with a spanner wrench and remove
retaining ring (1) as shown in Figure 61.
4. Grasp end of shaft (6); extract shaft, head (3), and
piston (8) by carefully twisting and pulling on the shaft.
IMPORTANT: Do not clamp vise jaws against shaft
(6) surface. Protect shaft surface before mounting
in the vise.
5. Mount shaft (6) securely in a vise by clamping vise
on the flats of the shaft. Remove locknut (10) and piston
(8) from the shaft. Slide head (3) off the shaft.
Figure 61
Removing retaining ring
Spanner
wrench
Retaining
ring
6. Remove and discard O–ring (7) and uni–ring (9)
from the piston (8). Remove and discard both O–rings
(2 and 5) and backup washer (4) from the head (3).
Hydraulic
System