Filter
Top Products
OPERATION
OPERATION
Operation Section 4-25
© 2006 Alamo Group Inc.
FLX15/10 04/06
Operating Position
To lower the wings, remove the transport lock pins and secure pins at storage location. DO NOT drive out
transport pins that have tension on them. After removing pins, extend wing hydraulic cylinders and fully lower
wings.
Wing hydraulic control valves should be set in the float detent during operation to allow the mower to follow the
contour of uneven terrain and to prevent the wings from creeping up. When extending a wing over a ditch for
mowing, place the control valve lever detents in the center position for greater stability.
Transport Position
To raise mower wings, drive the unit to a level area and
retract the wing hydraulic cylinders. DO NOT raise
wings with the mower positioned on an embankment
DANGER!
When the Wings are folded for transport, the center of gravity is raised and the possibility of
overturn is increased. Drive slowly and use extreme caution when turning on hillsides.
Overturning the Implement could cause the Implement to overturn the Tractor and vice versa
resulting in serious injury or even death. Never fold wings on a hillside...the Implement may
overturn. (STI-2)
WARNING!
Use extreme care when lowering or unfolding the implement’s wings. Make sure no
bystanders are close by or underneath the wings. Allow ample clearance around the
implement when folding or unfolding the wings. Use extreme caution around buildings or
overhead power lines. (S3PT-5)
Wing Transport
Lock Pin
Pin Storage
Location
XH1500/XH1000
FLX15/FLX10
Center Section
Transport Lock Pin
S150/S100