Filter
Top Products
OPERATION
Operation Section 4-24
OPERATION
© 2006 Alamo Group Inc.
FLX15/10 04/06
9.1 Starting the Tractor
The procedure to start the tractor is model specific.
Refer to the tractor operator’s manual for starting
procedures for your particular tractor. Consult an
authorized dealer if the starting procedure is unclear.
Ensure the 3-point control lever is in the lowered
position and the PTO is disengaged before starting
the tractor.
9.2 Brake and Differential Lock Setting
Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or
limit the tractor from turning. During normal mowing conditions, locking the differential provides no benefit and
should not be used.
Make sure the tractor brakes are in good operating
condition. Tractor brakes can be set to operate
independently allowing single rear wheel braking
action or locked together to provide simultaneous rear
wheel braking. FOR MOST DRIVING AND MOWING
CONDITIONS, THE BRAKE PEDALS SHOULD BE
LOCKED TOGETHER TO PROVIDE THE MOST
EFFECTIVE BRAKING ACTION.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty
brakes. When operating down a hill or on wet or rain slick roads, the braking distance
increases; use extreme care and reduce your speed in these conditions. When operating
in traffic, always use the Tractor’s flashing warning lights and reduce your speed. Be
aware of traffic around you and watch out for the other guy.
WARNING!
9.3 Operating the Mower Wings
Wings are positioned with hydraulic cylinders. Ensure the hydraulic cylinders and lines are filled with oil by
holding the valve control levers in the raised position until the cylinders fully retract (wings) and extend (center).
Only operate the mower with both wings fully lowered, NEVER operate the mower with a raised wing. Wait until
the blades are at a complete stop before raising wings.