Filter
Top Products
OPERATION
Operation Section 4-14
OPERATION
© 2006 Alamo Group Inc.
FLX15/10 04/06
NOTE: All cutters will have a strut mount lug welded to the cutter at the factory. If cutter is and older model and
does not come with the welded mounted lug, a retro-fit weld on lug kit is available for purchase at your local
dealer.The kit consist of lug, bolt & nut, a spray can or paint, and installation instructions. Costumer will be
required to weld lug then drill a 17/32” hole through the tube and pin the safety bolt through it (the hole is already
pre-drilled on the lug itself)
Mounting Lugs
8. Pin the strut assembly to the mounting lugs on
the arm and cutter with 1” bolts the length of the
strut from pinpoint to pinpoint should be set
according to chart below.
6. Securely attach the flex arm safety chain to the
mowers a-frame. Ensure the FLEX-ARM end is
securely attached through the Safety Chain
Attachment Location and is securely wrapped
around the mower “A” frame.
7. Lower the jack until the tongue is completely
supported by the drawbar. Remove jack from the
tongue and place on storage bracket of mower.
5.3 Connecting Mower Hydraulic Lines to the Tractor
With the tractor shut down and secured in position, relieve hydraulic pressure from the tractor by moving the
control levers back and forth several times or placing the levers in the float position. Keep mower hydraulic lines,
hoses, quick couplers, and swivels free of contamination. Never leave a disconnected hose end open and cap the
tractor hydraulic outlet ports when not in use. If the tractor ports,Flex-Arm ports, or mower hydraulic hose ends
become contaminated, wipe clean with a rag before connecting.
DANGER!
Do not operate this Equipment with hydraulic oil leaking. Oil is
expensive and its presence could present a hazard. Do not check for
leaks with your hand! Use a piece of heavy paper or cardboard. High-
pressure oil streams from breaks in the line could penetrate the skin
and cause tissue damage including gangrene. If oil does penetrate the
skin, have the injury treated immediately by a physician knowledge-
able and skilled in this procedure. (SG-15)
Machine Strut length
XH1500 49-1/4”
XH1000 48-1/4”
S150 49”
S100 48”
Mower
A-Frame
Safety Chain
Attachment Location