Filter
Top Products
Introduction Section 2-2
FLX15/10 04/06
© 2006 Alamo Group Inc.
INTRODUCTION
INTRODUCTION
Your Flex Arm is designed to attach a 10' or 15' cutter it is primarily for weeds, grass, and brush up to 2" in
diameter. The Flex Arm allows the operator to travel on the road while the 10' or 15' cutter cuts the ditch slope. With
proper maintenance as described in this manual, your Flex Arm and Cutter will provide you with years of
dependable service with a minimum of repairs.
It is required that all operators of this implement read this manual or be instructed of its contents as to safety,
proper operation, and maintenance before beginning operation.
Your Flex Arm and Cutter have been assembled for operation with a tractor PTO input speed of either 540 or 1000
RPM. Should you desire to change PTO input speed, contact your local Tiger dealer who will assist you in
performing the necessary modifications. Use your existing CV driveline from your Tiger rotary cutter to connect the
Flex Arm to the tractor.
When ordering parts for the Gearboxes and the Drivelines, be sure to specify the serial number. The serial number
is located on the left hand side attached to the Flex Arm frame.
Driveline Integral Shields, and Gearbox Shields are standard equipment and are to be used at all times.
To place warranty into effect, fill out the warranty validation form in full and return it within thirty (30) days of the date
of purchase