Filter
Top Products
15
English
STARTING WARM ENGINE
Ensure that there is fuel and chain oil in the tanks. 1.
Move chain brake lever (E) fully forward to lock chain brake 2.
before starting.
Lay unit on a at, clear area and keep bar and chain clear of all 3.
obstacles. Hold top handle with one hand, and depress throttle trigger
lockout (C), but do not depress throttle trigger.
Move ignition/choke lever (A) forward to “Run” position ( I ).4.
Pull starter handle. 5.
RUNNING
E
D
WARNING DANGER
The saw chain should not move at idle, otherwise serious per-
sonal injury may result.
NOTE
If saw chain moves, adjust carburetor according to “Carburetor Adjust-
ment” instructions in this manual, or see your dealer.
NOTE
If engine does not stop, move ignition/choke lever forward to choke
position (
) to stop engine. Return the unit to your authorized
Shindaiwa dealer to check and repair stop switch before starting
the engine again
NOTE
If engine does not start after 5 pulls, use cold start procedure.
After engine starts, allow it to return to idle and warm up before using. ■
Move chain brake lever (E) fully rearward to unlock chain brake. ■
Press throttle control lockout (C) then gradually squeeze throttle ■
trigger (D) to increase engine speed.
Saw chain starts moving when the engine reaches approximately
■
4200 rpm.
Ensure proper acceleration and lubrication of chain and bar. ■
Do not run the engine at high speed unnecessarily. ■
Be sure that saw chain stops moving when throttle trigger is ■
released.
STOPPING
Release throttle trigger (D) and move lever (A) rearward to STOP 1.
(O) position.
Move chain brake lever (E) fully forward to lock chain brake. 2.
E
A
C
A
A
C
Operation, continued
C