Filter
Top Products
MAINTENANCE
Belt tension check
To check belts’ state of tension is necessary to check the compression level of the spring.
When spring’s length is 1-1.5cm over the pack length, it’s necessary to re-adjust belt’s tension.
MAINTENANCE
Belt replacement
Never replace one belt only. When a belt is worn, always replace all belts.
In order to replace belts, remove the safety guard by loosening the tightening screw, loosen linkage check rods,
remove belts and replace them with new ones.
Use belt type ROFLEX TS SPB 2580 L
d
.
After replacement of the belt reposition the safety guard and tighten bolts.
AGM 52-62-72-82 10/10
Maintenance Section 5-7
© 2010 Alamo Group Inc.