Filter
Top Products
OPERATION
Hydraulic System
Before connecting the hydraulic couplings (quick couplings) to the distributors of the tractor stop engine and operate
the distributors levels in both directions in order to make sure that the circuits of the tractor and the machine are not
under pressure.
Check hydraulic hoses for wear and scratches after every operation and replace them with new ones provided by the
Manufacturer if necessary.
If there is a leak stop the engine of the tractor, disengage PTO, relieve pressure in the hydraulic system, disconnect
hydraulic hoses using safety gloves (make sure you have a bin to collect used oil ) and replace them with new ones
supplied by the Manufacturer. Used oil is harmful according to the existing law, therefore it shall be collected properly.
Fluids under pressure such as oil in an hydraulic system can cause severe injury and infections. Seek medical
assistance if necessary.
Make sure that all couplings are clean and in good conditions before connecting the quick hydraulic hoses to the
tractor.
OPERATION
Make sure that all hydraulic hoses are installed properly.
Check wear on hydraulic hoses and replace them if
necessary (anyway at least every 6 years).
The hydraulic cylinder is supplied without oil.
Fill the hydraulic system and drive at least twice to the right and to the left respectively to check
proper connection of the system.
After mowing place hydraulic hoses in their brackets.
AGM 52-62-72-82
10/10
Operation Section 4-15
© 2010 Alamo Group Inc.