Filter
Top Products
9
Service and Adjustments
NEVER attempt to make any adjustments to unit while
engine is running. Stop engine and wait for all moving
parts to stop before servicing (except where
specifically recommended).
DO NOT make cutting height wheel adjustments while
the engine is running.
On self-propelled models, the wheel drive control will
cause the forward movement of the mower to stop. If
this feature fails to operate, disconnect spark plug wire
and repair before using unit. Wheel drive must be
disengaged when starting engine.
Fuel is highly flammable and its vapors can explode.
ONLY use approved fuel containers.
• NO Smoking!
• NO Sparks!
• NO Flames!
• Allow engine to cool before filling fuel tank.
Check fuel supply before starting engine.
DO NOT fill gasoline tank indoors, when engine is
running, or while engine is still hot.
Allow engine to cool several minutes before removing
fuel cap.
Replace gasoline tank cap securely and clean up any
spilled fuel before starting engine.
Stop engine, wait for moving parts to stop, remove
ignition wire and secure away from spark plug before
attempting to: unclog, repair, adjust, inspect or clean
unit.
To reduce fire hazard and overheating, keep equipment
free of grass, leaves, debris or excessive lubricants.
Maintenance
Follow engine manufacturer’s safety instructions when
servicing engine.
Keep all nuts, bolts, and screws tight and be sure
equipment is in safe working condition. Check all
hardware at regular intervals, especially blade
attachment bolts.
Use only replacement parts designed for your unit. See
your Ariens Dealer.
Worn out mufflers are more than just a noise nuisance
and should be replaced immediately. Continued use
could result in fire or explosion.
ALWAYS block wheels and know all jack stands are
strong and secure and will hold weight of unit during
maintenance.
Check grass bag for wear, damage, and/or
deterioration. Replace only with Ariens original
equipment replacement part for safety.
Storage
Allow engine to cool before storing in any enclosure.
Refer to Storage Section of this Owner’s Manual for
important instructions if unit is to be stored for
extended periods.
ALWAYS clean unit before extended storage. See
engine manual for proper storage.
DO NOT store unit inside a building with fuel in the fuel
tank where any ignition sources are present.
Safety Interlock System
Engine/Blade Control feature on mower will cause
engine and blade to stop whenever operator releases
control on handlebar. If feature fails to operate,
disconnect spark plug wire and adjust or have it
repaired before using unit.
Accessories
Use only accessories which have been approved by
Ariens and are properly installed.
Spark Arrestor
This product is equipped with an internal combustion
engine. DO NOT use on or near any unimproved, forest
or brush covered land unless the exhaust system is
equipped with a spark arrestor meeting applicable
local, state or federal laws. A spark arrestor, if used,
must be maintained in effective working order by the
operator. See your Ariens Dealer or engine
manufacturer’s service center.