Filter
Top Products
11
CONTROLS AND FEATURES
See Figures 1 and 6 for Controls and Features.
Engine/Blade Control
The Engine Control must be held
against the handlebar in order to start
the engine as well as during mowing
operations to keep the engine running.
Releasing the control during operation stops the
engine and blade.
Handlebar
Handlebar adjusts to four positions by selecting holes
in braces. Select a safe, comfortable height and place
pin through hole in brace that is closest to that height.
Refer to Adjustment Section for instructions.
Recoil Starter Handle
When pulled, handle will turn engine over.
Cutting Height – Standard Models
To change cutting height, move cutting height levers
one notch at a time on each wheel until desired height
of cut is obtained. (Figure 6)
NOTE:
Each Wheel on mower must be set at the same
height for a level cut.
WARNING:
DO NOT attempt to start your
engine at this time. Familiarize yourself with
controls to see what they do and how they
work. Thoroughly read and understand entire
Operators Manual first.
CAUTION:
Check function of Engine/Blade
Control regularly. Improper function of control
could cause injury.
DANGER:
To avoid inadvertent blade contact,
NEVER attempt to make any cutting height
adjustment while engine is running.
CAUTION:
On self-propelled models, both
rear wheels must be positioned at same
height or traction drive may not clutch or
operate properly.
OM0450
Cutting Height Settings Chart
Notch Cut grass length
LOW
1" (25 mm)
2
1-3/8" (35 mm)
3
1-3/4" (45 mm)
4
2-1/4" (57 mm)
5
2-3/4" (70 mm)
HIGH
3-1/4" (83 mm)
Low
High
Figure 6
Rear
3
4
5
1
2
OM0190
OM0180
1. Cutting Height Lever
2. Notches
3. Clevis Pin & Swivel Height Adjustment Holes
4. Swivel Lock Hole (Swivel Locked)
5. Linchpin Storage Hole (Free)
Front Swivel
OPERATION