Filter
Top Products
10-3-8 FUEL TANK
1) Attach the strainer, nut, and banjo to the strainer bracket.
2) Remove the front panel from the control box, and mount the strainer bracket.
5q5~12mmbolt...2pcs.
Mount the front panel again.
3) Mount the fuel tank on the side plates with rubber washers between the side plates and the fuel tank.
84x 18mmbolt...4pcs.
4) Connect the rubber pipes.
First, fit the hose clamps on the rubber pipe, connect the strainer and fuel tank, fasten the rubber pipe with the
hose clamps.
NOTE: Keep the strainer in the off position until the pipe has been connected.
(See F&. 10-33.)
\
/FUEL TANK
FUEL GAUGE
RUBBER PIPE 1 .
II I
\-----
I-
HOSE
CLAMPS
STRAINER
u I
gK,q\
‘RUBBER PIPE 2
CONTROL BOX
‘FUEL STRAINER
Fig. lo-33
- 57 -