Filter
Top Products
Order
3
Item
Frame
Procedure
Remarks
I
TOOi
(1) Remove the box stay.
, It is not necessary to re-
10 mm spanner
69 bolt. . . 2 PCS.
move the air guide.
(2) Remove the side plates, front and rear.
(3) Remove the generator mounting nuts.
Black special bolts are
used.
10 mm spanner or
box spanner
13 mm spanner
I
I
/
RGX305, RGX305D: Remove the \
nuts that fasten the engine and rubber (
mount and the nuts that fasten the
generator and rubber mount. I
89 nut . . .4 PCS.
I
I
I
I
RGX405: RGX405D, RGX505, RGX
/ The bolts are welded to
505D :
Remove the nuts that fasten
the engine base.
the engine to the engine base, and the
nuts that fasten the rubber mount the
generator. (See Fig. 1 O-7.)
- ,
I
ag nut . . .6
PCS.
!
I
I
(4) Remove the generator.
Be careful of the genera-
1
(See Fig. 10-8.)
’ tor balance.
Lift the generator with a chain block,
j
and remove the frame.
I
(5) Remove the rubber mount.
I
Rubber mount is fastened i 13 mm spanner or
RGX405, RGX405D, RGX505, RGX
’ with the nuts welded to
box spanner
!
505D: Remove the nuts that fasten
the bottom of the frame.
/
:
I
the engine base and rubber mount.
Twist the rubber mount and take it
\
off.
i
Fig. 10-7
-45-
Fig. 10-8