Filter
Top Products
NOTE: The mounting dirmtion of the brush holders for Models RGX405, RGX405D, RGX505 and RGX 505D
isshown in Fig. lo- 28
GREEN
BROWN
WIRE
WIRE
Fig. lo-28
NOTE: If a brush is installed oblique to the slip ring, the brush holder
can
break tien the screw is tightened; or the
brush may break when the generator is started.
After installing the brush holders, measure the resistances across the bnrshes and terminals with a tester if they am
from 5 ohms to 7.5 ohms.
If so, the brush holders am corracdy mounted.
2) Attach the connectors to the brush holders.
Connect the green wire to the stator end and the brown wire to the bearing end. (See Fig. 10-28.)
3) Install the brush cover.
RGX305, RGX305D:
4tp x 8 mm screw . . .2 PCS.
RGX405, RGX405D, RGX505, RGX505D:
5~xlOmmscrew...2pcs.
10-3-6 FRAME
1) Attach the rubber mounts to the frame.
Tighten the rubber mounts on the nuts welded to the bottom of the frame.
RGX305, RGX305D.. .4 PCS.
RGX405, RGX405D, RGX505, RGX505D . . .6 pcs.
NOTE: The rubber mounts are so seltxted as to assure optimum vibration depending on model and frequency. Be
sure to use the rubber mounts of the correct parts number. Rubber mounts may appear the same in shape but differ
in hardness.
P 1
2) RGX405, RGX405D, RGX505, RGX505D:
Install the engine base. (See Fig. 10-29.)
Benuts.. .4pcs.
Fig. lo-29
- 55 -