Filter
Top Products
10-3 HOW TO REASSEMBLE
10-3-l FRONT COVER
Attach the front cover to the engine main bearing cover.
Match the faucet joint, and tighten the bolts.
8$xlSmmbolt...4pcs.
Tightening torque 120 to 14Okg-m
NOTE: Make sure that the slits for cooling air
an?
dew.
NOTE: The RGX405, RGX405D and RGX505 RGX
505D use the same front cover.
10-3-2 ROTOR
1)
2)
Clean the tapered part of the engine output shaft and
the female tapered shaft of the rotor shaft of oil and
other foreign matter with waste cloth.
Install the rotor and tighten the through-bolt. (See
Fig. 10-18.)
Tighten the through-bolt by striking a box spanner
or socket wrench hard clockwise.
NOTE: The outside diameter and lamination thick-
ness of tie rotor is shown in Item 12) Rotor, Para-
graph 5- 2 Functions.
NOTE: The tiro;rgh-bolt is shaped as shown below.
Fig. lo-17
Fig. lo- 18
RGX405 ’ 10 mm 230 mm 25 mm
RGX405D 0.39 inch
9.06 inch 0.98 inch
RGX505 ’
10mm 260 mm i
25 mm
RGX505D 0.39 inch 10.24 inch 1 0.98 inch
Table 10-3
-51-