Filter
Top Products
10-3-9
CONTROL PANEL
Mount the control panel assembly to the control box.
Refer to Section
10-4
for disassembly, checking and reassembly procedures of the control panel.
(1)
Connect the wires from the control panel and
(2)
Connect the wires drawn
out
from the stator to
the engine.
the wires from the control panel.
NOTE
:
Connect the wires
of
the same color.
(3)
Press the upper end
of
the bushing into the
(4)
Mount the control panel to the control box.
bottom window of the control panel.
M5 x
12
mm bolt
and
washer Ass’y
. .
.8
pcs.
Fig.
10-35
~ ~~
10-4
CHECKING, DISASSEMBLY
and
REASSEMBLY
of
the
CONTROL
PANEL
10-4-1
CHECKING
OF
THE CONTROL
PANEL
Dismount the control panel from frame. Remove the control panel and check each components and
wiring. Refer to Section
9
for the detail of checking procedure for the components in the front panel.
10-4-2
DISASSEMBLY
(1)
Remove the control panel from the control box.
M4 screw
. .
.8
pcs.
(2)
Disconnect the connectors on the wires to detach the control panel.
(3)
After disconnecting individual wires, remove the control panel components.
NOTE
:
Full power
switch
and pilot lamp have their wires soldered. Unsolder them to remove those parts
if necessary.
-
51
-