Filter
Top Products
10-3
ASSEMBLY
PROCEDURES
10-3-1
ENGINE
and
FRAME
(1)
Attach the mount rubbers to the frame. Insert
the setting tongue of mount rubber into the hole
.on the frame and tighten the nut from the bot-
tom
of
the frame.
M8
flange nut
. .
.4
pcs.
11.8
-
13.7
N-m
120
-
140
kg-cm
8.7
-
10.8
ft-lb
FRAME
UPPER
-
Fig.
10-22
NOTE
:
The mount rubbers are selected to reduce vibration most effectively by model. Be sure to use the
correct mount rubber for your generator. Although mount rubbers have the same appearance,
their characteristics are different.
(2)
Install the engine into the frame from the
side
of
it.
Tighten the nuts over the mount rubber bolts to
fix.
M8
nuts
. .
.2
pcs.
120
-
140
kg-crn
8.7
-
10.8
ft-lb
NOTE
:
Remove the air cleaner cover for easier installation.
NOTE
:
When tightening the nuts, slightly
lift
the engine
so
that the weight is not applied to the mount
rubbers.
10-3-2
FRONT
COVER
Attach the front cover to the engine main bearing
cover. Match the faucet joint and tighten the bolts.
M8
x
20
mm
bolt.
.
-4
pcs.
M8 spring washer.
.
.4
pcs.
11.8
-
13.7
N-m
120
-
140
kg-cm
8.7
-
10.1
ft-lb
Fig.
10-23
-
45-