Filter
Top Products
10-3-6
BRUSH
/
BRUSH HOLDER
(1)
Install the brush holders in the rear cover. Pass
the mounting screws through the brush hold-
ers, push the brush holders
so
that the brushes
will be perpendicular to the slip rings, and
tighten the screws.
NOTE
:
There are two kinds of brush holders.
If
a brush is installed oblique to the slip
ring, the brush holder can break when
the screw is tightened
;
or the brush may
break when the generator of started.Afier
insblling the brush holders, measure the
resistances across the brushes and ter-
minals with a tester if they are from
5
ohrms to
7.5
ohrms. If
so,
the brush hold-
ers are correctly mounted.
Fig.
10-29
(2)
Attach the connetors to the brush holders. Connector the green wire to the stator end and the
brown wire to the bearing end.
(3)
Fix
the brush cover with
two
bolt and washer
Ass'y.
10-3-7
MUFFLER
and
MUFFLER
COVER
(1)
Assemble the exhaust pipe to engine.
M8
nuts
.
.
.2
pcs.
Tightening torque
22.5
-
26.5
N-m
230
-
270
kg-
'
16.6
-
19.5
ft-lb
(2)
Assemble the muffler bracket to the muffler.
(See
Fig.10-30.)
M8
flange nuts
.
.
.4
pcs.
fler.
(See
Fig.10-30.)
M6
x
12
mm
flange bolts
.
.
.2
pcs.
(3)
Assemble the muffler cover (rear) to the muf-
I
-
48-