Filter
Top Products
7
6.0 Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Lathe is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Some parts can be found in separate boxes
packed around the Lathe. Missing parts, if any,
should be reported to your distributor. Read the
instruction manual thoroughly for assembly,
maintenance and safety instructions.
6.1 Contents of shipping container
1 Lathe Bed, with Headstock, Tailstock, & Tool
Support Base – (A)
2 Leg Assemblies – (B)
1 Guard – (C)
1 Tool Support, 14” – (D)
1 Face Plate, 3” – (E)
1 Live Center – (F)
1 Spur Center, 1” – (G)
1 Index Pin – (H)
1 Live Center Pin – (J)
1 Knockout Rod – (K)
1 Face Plate Wrench – (L)
1 Tool Caddy – (M)
4 Levelers – (N)
10 Socket Hd. Cap Screws, 3/8” x 1-1/4” – (O)
10 Lock Washers, 3/8” – (P)
8 Flat Washers, 3/8” – (R)
1 Owner's Manual (not shown)
1 Warranty Card (not shown)
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.