Filter
Top Products
67
N
ote that the PA and External Speaker functions operate only on the Master
radio.
15.4.1.5 Multiple Radio and Data Operation
Only the master radio supports mobile data operation.
15.5 MACRO KEY OPERATION
Macro key operation permits the user to accomplish a series of keystrokes with a single "macro" keystroke.
Up to ten (10) macro keys can be defined, each capable of executing up to twenty (20) keystrokes, to any
pushbutton input (i.e., keypad keys, buttons, etc.). Each macro key can be pre-programmed to activate
when pressed or when released.
A macro key can also be pre-programmed to change the keystroke sequence the next time the macro key is
activated.
For detail operation and assignment of macro keys, contact your communications supervisor or
administrator.
15.6 INTERCONNECT CALL (SYSTEM MODEL ONLY)
To send a manually entered telephone interconnect call:
1. Select a channel in the radio system that has telephone interconnect capability. The radio should
be programmed for DTMF operation on this channel.
2. Press the k button to toggle the keypad to the DTMF function (secondary function).
3. Press and hold PTT to key the transmitter. While holding the PTT, press the * or # key (as
required by the radio system to obtain a telephone line). The radio will transmit the selected tone.
4. Release the PTT and listen for a dial tone. When the dial tone is heard, press and hold the PTT
while entering the desired telephone number. As each digit is entered and transmitted, the DTMF
side tone will be heard from the speaker, if programmed to do so through ProGrammer.
5. After all the digits have been entered and transmitted, release the PTT.
6. When the call is answered, press the PTT and speak directly into the microphone. Release the
PTT immediately to receive a reply.
7. When the call is finished, press and hold PTT and then press the * or # key (as required by radio
system) to terminate the interconnect call. Release the PTT.
8. To return to the primary function of the keypad, press k. To continue with another
interconnect call, repeat steps 3 through 8.
15.7 KEYPAD REMAPPING
If the keys have been remapped to provide new functions, fill in the following templates (Figure 15-1 and
Figure 15-2) for future reference.