Filter
Top Products
36
11.6 SYSTEM/GROUP/CHANNEL SELECTION
In the following description of SYSTEM/GROUP/CHANNEL SELECTION, the term group is used for
both group and channel.
The M7100
IP
SYSTEM/GROUP/CHANNEL knob and the RAMP controls, , and ., are
programmable for maximum flexibility. If the SYSTEM/GROUP/CHANNEL knob is assigned to select
groups, then the RAMP controls, , and ., are assigned to select systems. If the
SYSTEM/GROUP/CHANNEL knob is assigned to select systems, then the RAMP controls, , and .,
are assigned to select groups. System, group, and channel selection is the primary function for these
controls.
Either systems or groups can also be selected by entering the select mode and following the selection mode
rules described earlier. The system select or group select modes are entered by pressing S or g,
respectively, from the standard receive mode. Using the RAMP controls, , or ., after entering a
particular selection mode in this manner is the secondary function of these keys.
11.6.1 System Selection
Several methods, some of which depend on programming, can be used to select a new system.
These procedures are presumed to be starting from the normal receive display.
METHOD 1:
If system selection is programmed to the SYSTEM/GROUP/CHANNEL knob,
select a system by turning the SYSTEM/GROUP/CHANNEL knob to the desired
system position. The display registers the new system name on line 1. If the wrap
option is OFF and the knob is moved to a position greater than the number of
programmed systems, the highest programmed system will remain selected.
METHOD 2:
If system selection is programmed as the primary function of the RAMP control
, and ., select a system by pressing , or . to scroll through the system
list. The display registers the new system name on line 1.
METHOD 3:
Press S to enter the system select mode and follow the selection mode rules
detailed earlier. Press the RAMP controls, , or ., to scroll through the
systems.
11.6.2 Group and Channel Selection
Several methods, some of which depend on programming, can be used to select a new group or
channel. These procedures assume starting from the normal receive display.
METHOD 1:
If group selection is programmed to the SYSTEM/GROUP/CHANNEL knob,
select a group by turning the SYSTEM/GROUP/CHANNEL knob to the desired
group. The display registers the new group name on line 2. If the wrap option is
OFF and the knob is moved to a position greater than the number of programmed
groups, the highest programmed group will remain selected.
METHOD 2:
If group selection is programmed as the primary function of the RAMP controls,
, and ., select a group by pressing , or ., to scroll through the group
list. The display registers the new group name on line 2.