Filter
Top Products
GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08) — PAGE 21
Figure 21. Hot Lamp Surface
DANGER - HIGH VOLTAGE POWER LINES
When raising mast, ALWAYS be on
the lookout for overhead obstructions
such as high voltage power lines. The
possibility exists of electrocution,
even death, if the GloBug comes in
contact with
high voltage power lines
.
GLOBUG 4-SPOT — OPERATION
Applying Power
1. Make sure the generator lamp switch (Figure 19) is in
the OFF position.
Figure 19. GeneratorLamp Switch
4. Leave the engine idling for about 3 minutes to warm it
up.
5. Place the generator lamp switch (Figure 19) to the ON
position.
6. The lamp should light up and give a fully bright light in
about 5 minutes. If the lamp is not on, check all
connections and repeat steps 1 through 5. If the lamp
still does not come on contact the MQ service
department.
Shutdown
1. Place the generator lamp switch (Figure 19) to the OFF
position.
2. Disconnect the GloBug 4-Spot AC power cable from the
generator.
3. Shutdown generator as referenced in the "Shutdown
Section" of the supplied generator manual.
CAUTION - LAMP COOL DOWN
Allow a sufficient amount of time (15-20 minutes) for the
lamp to
cool down
before turning on lighting unit again.
Do not touch lamp before cooling down. Lamp surface is
very hot and can cause burns (Figure 21).
STARTER KEY
GENERATOR
LAMP SWITCH
CAUTION - READ GENERATOR MANUAL
Before attempting to operate the
generator, READ the entire operation
section of the manual. Failure to read
manual could cause severe damage to
the equipment and bodily harm to the
operator.
2. The GloBug has a power requirement of 120 VAC, 60 Hz
@ 18 amps. Connect the GloBug 4-Spot AC power cord
to the 120 VAC twist-lock receptacle (Figure 20) on the
the supplied generator.
Figure 20. 120 VAC Receptacle
3. Start the generator as referenced in the "Start-up
Section" of the supplied generator manual.
20A
120V
120 VAC
TWIST-LOCK
RECEPTACLE
GLOBUG 4-SPOT
POWER CABLE
TYPICAL
GENERATOR
FRONT PANEL
CAUTION - GENERATOR DAMAGE
DON NOT shut down generator engine with the lamp
switch on. This could cause damage or break the
generator.