Filter
Top Products
GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08) — PAGE 17
GLOBUG 4-SPOT — COMPONENTS
Figure 6 shows the location of the controls and components
for the GLOBUG 4-SPOT. The functions of each control is
described below:
1. Reflex Mirror – Enhances lighting from the bulbs.
2. Lighting Unit – Consists of 4 lamps in their sockets.
3. Lamp Stand – holds the four lamps of the lighting unit
together.
4 Lamp – 400 watt metal-halide type lamp. Replace with
only MQ recommended type lamp. Always allow a
sufficient amount of time for the lamp to
cool down
before changing.
5. Adjust Lever – This lever allows the lamp to be
positioned up or down. Turn counterclockwise to release
lamp and position. Turn clockwise to tighten.
6. Fold Lever – Holds the lamp stand in place after
adjusting its height.
7. Lamp Power Cable – Connects the lamps to the power
(generator).
8. Mast – This mast is comprised of three separate stages.
The mast can be raised in excess of 13.78 feet. (4.2
meters). Again when raising the mast, always be on the
lookout for overhead obstructions.
9. Mast Winch – Use this winch to raise and lower the mast.
Always be on the lookout for overhead obstructions.
Keep immediate area free of bystanders and debris when
raising the mast.
10. Winch Handle– Use this handle to adjust the mast
height.
11. Lift Hanger – When lifting of theGloBug is required
always use a suitable lifting device of adequate lifting
capability. NEVER stand underneath the GloBug while it
is being lifted.
12. Steering Handle – The GloBug can be moved in either
a forward or reverse direction by pulling back or pushing
forward on the T-handle. In addition the front wheels are
designed to turn in the opposite direction of the T-handle
placement thus allowing the GloBug to turn either left or
right.
13. Counterweight Lever – Holds the outriggers in place
when deployed.
14. Locking Clamps – To secure the generator to the
GloBug cart platform, place clamps (4) around the pipe
frame of the generator. Tighten securely to prevent
movement.
15. Outriggers – ALWAYS deploy the outriggers when
raising the mast.
16. Guide Square Pipe - frames the generator.
17. Brake Pedal – Step on this pedal to apply the brakes. To
release the brakes, press down on brake pedal again.
18. Cart – Holds the generator that supplies power to the
lighting unit.
19. Tires – The GloBug 4-Spot uses 4 pneumatic type tires.
Replace with only recommended type tire . NEVER allow
the rear tires to go flat. This could adversely affect the
braking system. Inflate tires to 35.5 psi (245kPa).
20. Catcher – Holds the outrigger in place in the stow
position.
21. Brake Pad – When the brake pedal is pressed, this pad
will strike and hold the rear tires in place. Make sure rear
tires are inflated to the correct air pressure.