Filter
Top Products
PAGE 10 — GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08)
GLOBUG 4-SPOT — RULES FOR SAFE OPERATION
The
DANGER
items listed below and on the next page are
considered
High DANGER
areas and should be adhered
to. Failing to understand these areas could result in
Bodily
Harm, Electrical
Shock
,
Electrocution
, and even
Death!
Please pay close attention when operating the lighting
system.
DANGER - GloBug High Danger Areas
■
When transporting the GloBug 4-Spot, lower the mast
fully
.
Tighten the lamp adjustment lever and make sure
that the lighting unit assembly is fixed to the mast before
transporting. This will prevent the light assembly from
falling down or being damaged during transport.
LAMP SAFETY AND CARE
■
NEVER leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
■
ALWAYS make sure the lamp surface is clean and dry.
■
ALWAYS replace with MQ recommended type lamp. See
parts section of this manual.
■
NEVER use force when installing a lamp. Excessive force
could cause the lamp to break causing bodily harm.
■
NEVER attempt to replace lamp with the power on. Always
unplug the power cord from the generator when changing
the lamp.
■
ALWAYS allow a sufficient amount of time for the lamp to
cool
before changing. The possibility exists of severe
burns.
■
ALWAYS have a
trained technician
to install and remove
lamp, or replace any damaged fixture wiring.
The GLOBUG 4-SPOT is equipped
with a
ground terminal
for your
protection. ALWAYS complete the
grounding path
from the lighting
system to an external grounding source.
ALWAYS make certain the GloBug is well grounded and
securely fastened to a good earth ground (ground rod). The
possibility exists of
Electrical Shock, Electrocution, and
even Death
if the GloBug is not grounded.
DANGER - Grounding the GloBug for Operation