Filter
Top Products
GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08) — PAGE 5
■
ALWAY S make sure that the GB12BW (tripod) lighting
system is placed on secure firm level ground so that it
cannot slide or shift around, endangering workers. Also
keep the immediate area free of bystanders.
■
ALWAYS keep area behind lighting system clear of people
while raising and lowering mast.
■
To prevent the lighting system from overturning, NEVER
use in winds that exceed 22 mph(10m/s).
■
To prevent the GB12BW (tripod) lighting system from
tipping, ALWAYS place tripod on a firm flat surface.
Surface slant should not exceed 5 degrees.
■
The GloBug lighting system should only be used in
temperatures between 23°-104° Fahrenheit (-5° to 40°
Celsius). Failure to comply with these operating
parameters could cause the lamp to malfunction and
shorten the ballast life.
■
NEVER use any GloBug lighting system in
rain, snow
or areas of high humidity that could generate electrical
storms.
■
CHECK the mast for any deformations. Replace mast if
defective.
■
NEVER attach anything to the mast.
■
ALWAYS lower the mast when not in use, or if high winds
or electrical storms are expected in the area.
MAST SAFETY
■
When raising or lowering the mast, keep
hands and fingers clear of the various
mast sections, this will prevent hands
and fingers from getting pinched.
GB12BW/BS/BP LIGHTING SYSTEM — RULES FOR SAFE OPERATION
WARNING - READ THIS MANUAL
Failure to follow instructions in this manual may lead to
Serious Injury
or even
Death
. This equipment is to be
operated by trained and qualified personnel only! This
equipment is for industrial use only.
The following safety guidelines should always be used
when operating GloBug Lighting System.
The following safety guidelines should always be used when
operating any GloBug Lighting System:
GENERAL SAFETY
■
DO NOT operate or service this
equipment before reading this entire
manual.
■
This equipment should not be operated by persons under
18 years of age.
■
NEVER operate this equipment without proper protective
clothing, shatterproof glasses, steel-toed boots and other
protective devices required by the job.
■
NEVER operate this equipment under the influence of
drugs
or
alcohol
.
■
Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■
Manufacturer does not assume responsibility for any
accident due to equipment modifications.
■
NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage
to the equipment and/or injury to user may result.
■
NEVER operate this equipment when not feeling
well due to fatigue, illness or taking medicine.
PINCH
POINT
MAST