Filter
Top Products
PAGE 16 — GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08)
GLOBUG GB12BW/BS/BP LIGHTING SYSTEM — SETUP (GB12BW)
CAUTION - READ MANUAL
Please read this entire manual carefully
before attempting to operate any of the
GloBug Lighting Systems referenced in
this manual. Failure to read this manual
could cause damage to the equipment and serious bodily
injury to the operator.
Tripod Deployment (GB12BW)
1. Place the tripod on a
firm level surface
so that it will
not slide or turn over. Make sure there is enough space
around the unit for the tripod legs to be deployed.
2. Remove tripod from its carrying case. The tripod legs
are secured by a black velcro strap (Figure 8). Squeeze
both tabs on each side of buckle to unlock strap and
allow tripod legs (Figure 9) to be deployed.
Figure 8. Velcro Strap (Open)
3. Next, pull upward on the mast and let the tripod legs
deploy. Once the tripod legs have been fully deployed
make sure the legs are locked by securing the latch.
The latch (Figure 10) has two positions, upper and lower.
Placing the latch in the upper position will provide 1 ft. (
305 mm) more height.
SQUEEZE
VELCRO
STRAP
BUCKLE
TRIPOD
LEGS
DEPLOYMENT
Figure 9. Tripod Deployment
LATCH
UPPER
LOWER
MAST
Figure 10. Securing the Tripod