Filter
Top Products
GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08) — PAGE 15
GB12BW/BS/BP LIGHTING SYSTEM — COMPONENTS
Figure 7 shows the location of the components for the GloBug
lighting system. The function of each component is described
below:
1. AC Power Cable – Connect this cable to a 120 VAC, 60
Hz power source.
2. Lamp Power Cable – Quick-disconnect cable. Provides
AC power to lamp assembly.
3. Balloon – This balloon is made of heat-resistant polyes-
ter, with a diameter of 33 inches (850 mm).
4. Balloon Cover/Carrying Case – When zipped, this
protective cover acts like a carrying case. The complete
lamp assembly is enclosed within the cover-carrying
case. Allow a sufficient amount of time for the lamp to
cool down before covering balloon. The possibility exists
of the balloon getting burned.
5. Mast – Two stage air-assist mast. Maximum mast height
is 10 ft. (3 meters) without optional extension pole. With
optional extension pole, height increases to 13 ft. (4.0
meters). When raising the mast, always be on the lookout
for overhead obstructions.
6. T-Handle Bolt Lock – Always tighten this lock to hold the
lamp/balloon securely in place before raising mast.
7. Tripod Release Latch– Use this latch to deploy and lock
tripod legs. For ease of use, the latch mechanism is
attached to a velcro strap.
8. Tripod – Unbuckle velcro strap securing tripod legs (3),
push down on any tripod leg until all tripod legs are fully
deployed. To place tripod legs in the stow position, pull
upward on velcro strap while pushing down on tripod
pole. Pull all legs upward and secure with velco strap.
9. Lamp Guard – This guard (cage) protects the lamp from
being hit by objects.
10. Lamp – 400 watt metal-halide type lamp. Replace only
with MQ recommended type lamp. Always allow a
sufficient amount of time for the lamp to
cool down
before changing.
11. Fan Motor (Blower) – This electric motor is responsible
for inflating the balloon. It will supply a pressure of .6-inch
H
2
0 (.0217 psi /0.149 kPA). Please note that the balloon
will begin to inflate as soon as power is applied to the
lighting system.
12. Tripod Carrying Case – Use this case when transport-
ing of the tripod is required. ALWAYS store tripod in this
carrying case when not in use.
13. Offset Pole – Supports lamp assembly when attached to
the main mast. Included with the offset pole is a 17/19
mm wrench.
14. Main Pole – Used in conjunction with the offset pole to
support the lamp assembly.
15. Pole Clamps – Attach these clamps (2) to the main pole
and external support pole. to support. Always tighten
both clamps securely to prevent slippage of the light
assembly.
16. Weight Support Hook – To add additional weight to the
tripod and make the tripod more stable in windy condi-
tions. Place a sandbag or similar weight onto this hook.