Filter
Top Products
PAGE 30 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)
Setup 4-Up Display
1. From the single or four engine parameter display touch
the “Menu Button
2. The main menu will pop up on the display. Use the
“Arrow Buttons” to scroll through the menu until the
“Setup 4-Up Display” is highlighted.
3. Once the “Setup 4-Up Display” menu item has been
highlighted touch the “Enter Button” to activate the
“Setup 4- Up Display” menu.
4. Touch the “Enter Button” to activate the “Use Defaults”
function. This action will reset the unit to the factory
default.
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATT VOLT
ENG RPM
OIL PRES
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SELECT UNITS
SETUP-4-UP DISPLAY
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
ADJUST BACKLIGHT
SETUP 1-UP DISPLAY
SELECT UNITS
SETUP-4-UP DISPLAY
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
DIAGNOSTIC DISPLAY
5. The “Use Defaults” screen will be displayed during the
resetting period then will automatically return to the
“Setup 4- Up Display” menu.
6. Select the “4-Up Custom Setup” from the “4-Up Setup”
menu.
7. The quadrant with the backlit parameter value is the
current selected parameter. Use the “Arrow Buttons”
to highlight the parameter value in the quadrant you
wish to place a new parameter.
8. Touch the “Enter Button” and a list of parameters will
appear.
RESTORED TO
DEFAULTS
USE DEFAULTS
CUSTOM SETUP
USE DEFAULTS
CUSTOM SETUP
125°F
COOL TEMP
14.2
57 PSI
1000 RPM
BATTVOLT
ENG RPM
OIL PRES