Filter
Top Products
THE MINELAB EXPLORER II
25
Figure 2.11 Fitting buckle to armrest strap
Figure 2.12 Fitting armrest strap to
armrest
Figure 2.13 Tightening armrest strap
Fitting the armrest strap
Figure 2.11–2.13
To fit and adjust the armrest strap:
STEP 1 (Figure 2.11) Thread the strap through the buckle openings
as illustrated.
STEP 2 (Figure 2.12) Clip both buckles into the openings at each
outer side of the armrest.
STEP 3 Test by sliding your arm underneath the strap and resting
your forearm on the armrest (which should be adjusted to a
comfortable setting).
STEP 4 (Figure 2.13) Loosen strap by tilting the edge of the buckle
out to release it from the armrest. Undo the velcro and pull
the buckle outwards (towards yourself). Clip the buckle back
into place and tighten the strap by pulling up (in the direction
of the top arrow in Figure 2.13).
The armrest should now be adjusted to your satisfaction. Next time
you use your detector, all you will need to do is click the buckle back
into the armrest.
THE HANDLE ASSEMBLY