Filter
Top Products
THE MINELAB EXPLORER II
19
Connecting the search coil to the lower shaft
Figure 2.1–2.3
CAUTION DO NOT attempt to disconnect the coil cable
where it enters the search coil itself. They are shipped
pre-assembled and any attempt to disconnect will void your
detector warranty.
To attach the search coil to the lower shaft:
STEP 1 Place the search coil on a flat surface close to the coil yoke.
STEP 2 (Figure 2.2, following page) Plug the two black plastic
washers into the recesses provided on either side of the coil
yoke.
CONNECTING THE SEARCH COIL
The search coil transmits electromagnetic signals into the ground and receives
the response.
CONNECTING THE SEARCH COIL
Figure 2.1 Connecting the search coil
to the lower shaft
(Continued next page)
Rubber Washer
Yoke Nut
Coil Yoke
Search Coil
Yoke Bracket
Yoke Bolt
Coil Cable
P0608-A