Filter
Top Products
THE MINELAB EXPLORER II
24
www.minelab.com
Adjusting the armrest assembly
Figure 2.10
To adjust armrest:
STEP 1 Loosen the screw in the center of the armrest (turn counter-
clockwise). Use a screwdriver or the edge of a coin.
STEP 2 Slide armrest to your desired position. Your hand should
comfortably grip the angled neck of the handle assembly,
with the detector feeling like an extension of your forearm.
STEP 3 Gently remove your arm.
STEP 4 Tighten screw (clockwise) to lock into position.
Figure 2.10 Armrest adjustment
THE HANDLE ASSEMBLY
The handle assembly is made up of the armrest, straps and the control box. It is
connected to the shaft assembly by the control box camlock.
THE HANDLE ASSEMBLY
P0268-C